Pelvis Popcan
Well-Known Member
- Joined
- Jan 28, 2007
- Messages
- 1,676
- Likes
- 60
That would be my guess as well, however, I would carefully remove *both* sound boards on top and check to make sure there are not ports that match the image in the guide located underneath the sound boards. I remember having to remove both of my sound boards because it wasn't really possible to properly reattach a ribbon cable unless both boards were removed. But I can't remember exactly where my TTL port was located. I agree though the port does not appear to be where it is shown in the guide. I do remember that on my 105 USA model the port location *did* match the guide.
Make sure you only connect ground, TX, and RX.
RX pin on board goes to TX pin on adapter, and TX pin on board goes to RX pin on adapter.
(Are you *sure* this is a 105?)
Make sure you only connect ground, TX, and RX.
RX pin on board goes to TX pin on adapter, and TX pin on board goes to RX pin on adapter.
(Are you *sure* this is a 105?)
Last edited: