I believe it has something to do with "DVD Rebuilder", because when I transcode, rebuild and burn a DVD with CloneDVD2 using Taiyo Yuden DVD-R at 4x CloneDVD2 works great. I use this method when the DVD movie only needs to be trancoded a little or none at all.
Now, when I use "DVD Rebuilder" to transcode, rebuild and CloneDVD2 to burn Taiyo Yuden DVD-R at 4x the Finished dialog never shows up and I have to shutdown the computer. I use this method when the DVD movie needs to be a lot more transcoded.
I'll change some settings in "DVD Rebuilder" and see if I can get CloneDVD2 to burn.
I pretty much exclusively use DVD-RB Pro to compress movies these days after ripping to my HDD as a DVD DL.
I did an experiment after reading this. Note that most of this work was already done except the burning.
Software Involved
Ahead Nero Vision 4.9.5.7
DVD Rebuilder Pro 1.25.0
Elaborate Bytes CloneDVD 2.9.0.3 [for ripping]
Elaborate Bytes CloneDVD 2.9.0.4 beta [for burning]
FixVTS 1.603
Slysoft AnyDVD HD 2.1.3.6
DVD drive
Plextor PX-760A [1.06 firmware]
Blank Media
Memorex DVD+RW [INFODISC-A10-001] - This is not my DVD+RW!
Process by which things were done
1. Ripped DVD to HDD as DVD DL with AnyDVD & CloneDVD 2.9.0.3
2. Ran the output through FixVTS even though it wasn't needed
3. Ran through Nero Vision to convert from PAL to NTSC format
4. Compressed to DVD-5 using DVD-RB Pro 1.25.0 with CCE using
One Pass VBR (w/analysis)
5. Burned to the blank DVD+RW using CloneDVD 2.9.0.4 beta at 8x
The burn completed successfully with no problems.
The reason I mentioned the other variables/methods is because it may or may not have impacted the outcome in my case. I never use CloneDVD to burn these days since I prefer to burn with a program that allows verification. Note that the reason I used two different versions of CloneDVD is that I had ripped the movie last night and then updated today.
Sorry that I can't come up with any reasons why this may be happening.