David Swartz
Member
Thread Starter
- Joined
- May 18, 2016
- Messages
- 8
- Likes
- 0
System: ASUS Z97-A ,CPU I7 4790K 4GHz;
OS Win 7 Home Prem 64Bit;
OS installed on HHD;
Scratch Drive: holds the "Target" (or Source BDMV folder) and the "Temp Folder" (or Working Folder
where the data is stored during the transcoding process).
The Scratch Drive is a RAID 0 of two 500GB SSDs mounted on an Apricorn Velocity Duo adapter.
I always check for and install the latest version of all software.
History: I had this system built in Feb 2015 and tested for stability for 36hrs+ with full updates. However, the Source and
Working folders were on the HHD. I experienced zero anomalies thru mid 2016.
I then purchased the SSDs and the Velocity Duo adapter and installed it in early summer 2016.
I had no anomalies in the first few months of use. Then gradually the subject anomaly became continuous.
My present (temporary) solution to the subject anomaly:
1. Proceed thru all of the proper steps required by CloneBD as if expecting nothing but normal operation.
2. Shutdown the computer via CTRL/ALT/DEL when Processing Aborts.
3. Restart the computer, open CloneBD, proceed thru each step as before without changing anything.
4. When I get to Conversion (and actually press the Conversion button) the CloneBD program will not let me
continue because some kind of data has been written to the Working folder and must be cleared.
5. After I clear the Working Folder by pressing the clear button the program starts and Graph is functional
and I get a cup of fine fresh brewed Italian Espresso from my new Espresso Machine.
This program stop has been the saving item for me as it is only a round about way to continue to get the job done.
But, it has become a real nuisance. Can this be corrected?
OS Win 7 Home Prem 64Bit;
OS installed on HHD;
Scratch Drive: holds the "Target" (or Source BDMV folder) and the "Temp Folder" (or Working Folder
where the data is stored during the transcoding process).
The Scratch Drive is a RAID 0 of two 500GB SSDs mounted on an Apricorn Velocity Duo adapter.
I always check for and install the latest version of all software.
History: I had this system built in Feb 2015 and tested for stability for 36hrs+ with full updates. However, the Source and
Working folders were on the HHD. I experienced zero anomalies thru mid 2016.
I then purchased the SSDs and the Velocity Duo adapter and installed it in early summer 2016.
I had no anomalies in the first few months of use. Then gradually the subject anomaly became continuous.
My present (temporary) solution to the subject anomaly:
1. Proceed thru all of the proper steps required by CloneBD as if expecting nothing but normal operation.
2. Shutdown the computer via CTRL/ALT/DEL when Processing Aborts.
3. Restart the computer, open CloneBD, proceed thru each step as before without changing anything.
4. When I get to Conversion (and actually press the Conversion button) the CloneBD program will not let me
continue because some kind of data has been written to the Working folder and must be cleared.
5. After I clear the Working Folder by pressing the clear button the program starts and Graph is functional
and I get a cup of fine fresh brewed Italian Espresso from my new Espresso Machine.
This program stop has been the saving item for me as it is only a round about way to continue to get the job done.
But, it has become a real nuisance. Can this be corrected?