TomTiddler
Well-Known Member
Thread Starter
- Joined
- Jan 31, 2007
- Messages
- 88
- Likes
- 13
I'm running CloneBD 1.1.2. BluRay was ripped with AnyDVD 8.0.9.0, and I've attached the CloneBD log file. The conversion process starts normally, gets to a time index of 00:00:15, at which point the video encoder input bar slowly drops to 0%, rapidly followed by all the other encoder bars, then CloneBD says "Finished", no error messages, no obvious problems, but it's only processed 56MB of the disk!
For the record I've tried this with no hardware acceleration, AMD acceleration, and Quicksync acceleration, all produce exactly the same behavior.
Any help would be appreciated, but it's not the end of the world if it never works
For the record I've tried this with no hardware acceleration, AMD acceleration, and Quicksync acceleration, all produce exactly the same behavior.
Any help would be appreciated, but it's not the end of the world if it never works