Sometimes CloneBD stops before the film ends....

Discussion in 'Issues and Bugs' started by Sirius76, Jun 12, 2019.

  1. Sirius76

    Sirius76 Member

    Noticed on some blu rays it happens at the same point each time..not sure why? No error appears and it acts as if it is finished but at a reduced length etc
     
  2. Sirius76

    Sirius76 Member

    For example, just trying Shark Night 3D (with AnyDVD decrypting) and not only does it stop at not much more than about half an hour (the film is near 90 minutes long), I also just noticed that even trying to play it in the preview doesn't work. Very peculiar because when I try to play towards the end (like 1h 20m) it just plays from around 27minutes. There is no way to play the part that it doesn't encode at. Even for the ones that had the full encoding problem before, I was still able to encode it in separate parts but this one can't even play those sections in the preview!! Plays fine in PowerDVD btw....
     
  3. Pete

    Pete Forum Admin Staff Member

    Please post a log file.