Reclock with Powerdvd 12

Discussion in 'ReClock' started by simon617, Feb 1, 2012.

  1. simon617

    simon617 New Member

    I installed Powerdvd 12 last night as an upgrade to 10. After the install I reinstaled reclock but would not run.

    I have now insaled the latest version but even though it shows up in the advanced tab, it does not appear in the task bar and i cannot see it running in task manager.

    Anybody got ant suggestions?
     
  2. hadar

    hadar Well-Known Member

    Sure. Wait until ReClock supports it?
     
  3. simon617

    simon617 New Member

    So does anybody know when Reclock it will support it?

    Also I'm a little annoyed that PowerDVD has so much judder without a third party to help it! :bang:
     
  4. Adbear

    Adbear Well-Known Member

    Well when you consider PDVD 12 only came out on the 1st of Feb (the day you installed it) it's hardly surprising it's not supported yet. I think the Slysoft team are probably busy on updating AnyDVD etc and will get round to it when they have time to work on a free piece of software
     
  5. simon617

    simon617 New Member

    I agree, my main issue is that I shouldn't have to have reclock to make PowerDVD to work properly.

    The slysoft products that I have are great.
     
  6. Simon, what do you mean "to make PowerDVD work properly?" I have PowerDVD 12 and it works fine. The only thing that bothers me is that it refuses to output 60fps or 72fps while viewing videos... And that I can't play my PAL DVDs in 24fps, of course...

    Do you experience bad synchronising from PowerDVD itself, because I can't seem to find any problem in it's synch when using TrueTheater Motion.
     
  7. James

    James Redfox Development Team Staff Member

    Try ReClock 1.8.7.8.
     
  8. Kevtech

    Kevtech New Member