1. Click
this
Do what it says to do.
Also, check to see if there's a better ide/ata busmaster driver available for you possibly from your motherboard's support website if Microsoft's default drivers aren't working well for you.
If you're not using Microsoft's default drivers, then please do.
2. visit
http://forum.slysoft.com/showpost.php?p=21907&postcount=11 (thanks to Zebadee)
Use one of the programs mentioned, and list your Lowerfilters and Upperfilters in your next post.
Or for XP users only,
Click Start, Run
type regedit
Go to
HKEY_LOCAL_MACHINE\SYSTEM\Current Control Set\Control\Class\{4D36E965-E325-11CE-BFC1-08002BE10318}
We want what's listed in "LowerFilters" and "UpperFilters". List your Lowerfilters and Upperfilters in your next post.
3. Update your burner's firmware (if available)
http://forum.slysoft.com/showpost.ph...4&postcount=10
4. Use good quality media
visit
http://www.redflagdeals.com/forums/s...3&postcount=25
and
http://www.redflagdeals.com/forums/s....php?p=3976250
5. Try lowering your burn speed (not below 4x; if you have a 16x burner and 16x rated media try writing to it at 12x instead of 16x)
6. If you're using +R, +RW, or +R DL media, change the booktype to "dvd-rom"
http://forum.slysoft.com/showthread.php?t=476 (step 3)
7. Avoid sticker labels (they tend to cause problems)
8. Try setting a custom size of 4300 in Clonedvd (but if you're using good media, you shouldn't have to)
Bad burn quality is notorious around the end of discs
and also at layer breaks when using low quality DL media (use Verbatim +R DL media, and change the booktype to "dvd-rom)