Splitting recording to 2 discs

Discussion in 'CloneDVD' started by ob1vette, May 16, 2007.

  1. ob1vette

    ob1vette New Member

    How do I split recording to two disks when one 4,7GB disk is insufficient? I am using Clone DVD. Please answer with very specific instructions. Thanks
    ob1vette
     
  2. Webslinger

    Webslinger Retired Moderator

    Please take a look at step 10 from here
     
    Last edited: May 16, 2007
  3. flyrfan111

    flyrfan111 Member

    Think you linked the wrong thread Webslinger. That 1 only goes to five and is about CloneDVD not working properly
     
  4. rambo

    rambo Well-Known Member

    It's obviously been a hard week and it's only Wednesday.
    poor chap!!!!!!
     
  5. ob1vette

    ob1vette New Member

    splitting to two discs

    how do I burn to two discs when one 4.7GB disc is not big enough?
    Please be very specific.:confused:
     
  6. mmdavis

    mmdavis Well-Known Member

    Should be step 10 from here.
     
  7. mmdavis

    mmdavis Well-Known Member

    Please see step 10 from here.
     
  8. Webslinger

    Webslinger Retired Moderator

    Thanks. Link fixed
     
  9. ob1vette

    ob1vette New Member

    Spliting movie recording to two dvd's

    After reading step ten, I am still having trouble spliting to two discs. Also for some reason many of the copies I make with Clone DVD2 I can only play back on my PC, not on my other two DVD players.
     
  10. Webslinger

    Webslinger Retired Moderator

    Describe your problem.

    1. Update your burner's firmware (if available)
    http://forum.slysoft.com/showpost.php?p=12794&postcount=10
    2. Use good quality media (Memorex, Ritek, Princo, Fuji, TDK from Costco, and Maxell that are not made in Japan are not good quality media)
    If you use poor quality blank media, then you should expect problems.
    visit http://www.redflagdeals.com/forums/showpost.php?p=4764653&postcount=25
    and
    http://www.redflagdeals.com/forums/showthread.php?p=3976250
    3. Try lowering your burn speed (not below 4x; if you have a 16x burner and 16x rated media try writing to it at 12x instead of 16x)
    4. If you're using +R, +RW, or +R DL media, change the booktype to "dvd-rom"
    http://forum.slysoft.com/showthread.php?t=476 (step 3)
    5. Avoid sticker labels (they tend to cause problems)
    6. Try setting a custom size of 4300 in Clonedvd (but if you're using good media, you shouldn't have to) if you're using regular single layer dvd-5 (4.7GB) discs.


    Bad burn quality is notorious around the end of discs (see step 6)
    and also at layer breaks when using low quality DL media (use Verbatim +R DL media, and change the booktype to "dvd-rom)