Movies skip

Discussion in 'CloneDVD' started by operator964, Oct 31, 2007.

  1. operator964

    operator964 New Member

    I don't know if anyone else has had this problem...When I attempt to backup a movie, everything works fine but when I watch it to verify the copy there are some points of the movie that skips. This happens to all movies that I make a copy for.

    Any suggestions??
     
  2. Webslinger

    Webslinger Retired Moderator

    Ensure you're using Anydvd 6.1.9.3

    Also . . . from Frequently Asked Questions (READ BEFORE YOU POST)

    1. Update your burner's firmware (if available)
    http://forum.slysoft.com/showpost.php?p=12794&postcount=10

    2. Use good quality media (Memorex, Ritek, Princo, Fuji, TDK from Costco, and Maxell that are not made in Japan are not good quality media). Are you using inferior blank media? If you're not using Taiyo Yuden Premium, Verbatim, Maxell Plus, or Maxell Broadcast Quality, then chances are the answer is yes.
    If you use poor quality blank media, then you should expect problems.

    visit http://www.redflagdeals.com/forums/showpost.php?p=4764653&postcount=25
    and
    http://www.redflagdeals.com/forums/showthread.php?p=3976250

    3. Try lowering your burn speed (not below 4x; if you have a 16x burner and 16x rated media try writing to it at 12x instead of 16x; an 8x burn speed on 16x rated media wouldn't be a bad idea either)

    4. If you're using +R, +RW, or +R DL media, change the booktype to "dvd-rom"
    http://forum.slysoft.com/showthread.php?t=476 (step 3)

    5. Avoid sticker labels (they tend to cause problems)

    6. Try setting a custom size of 4300 in Clonedvd (but if you're using good media, you shouldn't have to) if you're using regular single layer dvd-5 (4.7GB) discs.

    7. Download Nero cd-dvd speed. It's a free program. Select the tab labeled "scandisc". Insert the problematic backup disc, select the appropriate drive letter, and click "start". If Nero cd-dvd speed reports read errors, your backup is bad (which is the most likely case), your optical drive may be slowly dying, or your optical drive simply doesn't like the disc (or your choice of blank media)--even if the disc looks fine.


    Bad burn quality is notorious around the end of discs (see step 6)
    and also at layer breaks when using low quality DL media (use Verbatim +R DL media made in Singapore, and change the booktype to "dvd-rom")


    Also, check the preview screen in Clonedvd to ensure you're backing up the proper title.


    read http://forum.slysoft.com/showthread.php?t=476 fully please
     
    Last edited: Oct 31, 2007