Happy Feet

Discussion in 'CloneDVD' started by 1baddog, Apr 6, 2007.

  1. 1baddog

    1baddog Member

    :agree: Has anybody had any issues with the movie Happy Feet??? It acts like it goes threw everything fine and then writes the movie to the blank disc and then when I play the movie it works fine UNTIL track 8 were it will be playing along and then the movie freezes up and then after a little bit it will start up again. This is the first movie that I've encountered this happening.

    On another note I came over from XCopy DVD. (that software was a joke as was the tech support) I still got ripped off of my $40.00 but I learned a leason.! I think they called themselves Blings. I had EXCELLENT luck with this software and I told NUMEROUS (xcopy) people to COME OVER TO HERE.8)
     
  2. Webslinger

    Webslinger Retired Moderator

    Works fine with Anydvd and Clonedvd. visit http://forum.slysoft.com/showpost.php?p=20700&postcount=1


    1. Update your burner's firmware (if available)
    http://forum.slysoft.com/showpost.php?p=12794&postcount=10
    2. Use good quality media
    visit http://www.redflagdeals.com/forums/showpost.php?p=4764653&postcount=25
    and
    http://www.redflagdeals.com/forums/showthread.php?p=3976250
    3. Try lowering your burn speed (not below 4x; if you have a 16x burner and 16x rated media try writing to it at 12x instead of 16x)
    4. If you're using +R, +RW, or +R DL media, change the booktype to "dvd-rom"
    http://forum.slysoft.com/showthread.php?t=476 (step 3)
    5. Avoid sticker labels (they tend to cause problems)
    6. Try setting a custom size of 4300 in Clonedvd (but if you're using good media, you shouldn't have to)


    Bad burn quality is notorious around the end of discs
    and also at layer breaks when using low quality DL media (use Verbatim +R DL media, and change the booktype to "dvd-rom)


    Also, check the preview screen in Clonedvd to ensure you're backing up the proper title.


    read http://forum.slysoft.com/showthread.php?t=476 fully please
     
  3. mmdavis

    mmdavis Well-Known Member

    I don't have the movie so I don't know if it is a single or double layer DVD. If it is a double layer and the "pause" happens around the middle of the movie: If you used CloneDVD to copy the whole disc on a + DL disc, it is not uncommon to have a small "pause" at the layer break. It may be more evident with CloneDVD than CloneCD because CloneDVD changes the layer break position (and could be in a more noticeable part of the movie). You might try CloneCD with one and see if the problem occurs or is less evident. If you don't own it, you can try the 21 day trial to see how it works.