1. Update your burner's firmware (if available)
http://forum.slysoft.com/showpost.php?p=12794&postcount=10
2.
Use good quality media (Memorex, Ritek, Princo, Fuji, TDK from Costco, and Maxell that are
not made in Japan are not good quality media).
Use Taiyo Yuden 8x Premium, Verbatim, Maxell Plus, or Maxell Broadcast Quality
If you use poor quality blank media, then you should expect problems.
visit
http://www.redflagdeals.com/forums/showpost.php?p=4764653&postcount=25
and
http://www.redflagdeals.com/forums/showthread.php?p=3976250
3. Try lowering your burn speed (not below 4x; if you have a 16x burner and 16x rated media try writing to it at 12x instead of 16x; an 8x burn speed on 16x rated media wouldn't be a bad idea either)
4. If you're using +R, +RW, or +R DL media, change the booktype to "dvd-rom"
http://forum.slysoft.com/showthread.php?t=476 (step 3)
5. Avoid sticker labels (they tend to cause problems)
6. Try setting a custom size of 4300 in Clonedvd (but if you're using good media, you shouldn't have to) if you're using regular single layer dvd-5 (4.7GB) discs.
Bad burn quality is notorious around the end of discs (see step 6)
and also at layer breaks when using low quality DL media (use Verbatim +R DL media, and change the booktype to "dvd-rom)
Also, check the preview screen in Clonedvd to ensure you're backing up the proper title.
read http://forum.slysoft.com/showthread.php?t=476 fully please