• AnyStream is having some DRM issues currently, Netflix is not available in HD for the time being.
    Situations like this will always happen with AnyStream: streaming providers are continuously improving their countermeasures while we try to catch up, it's an ongoing cat-and-mouse game. Please be patient and don't flood our support or forum with requests, we are working on it 24/7 to get it resolved. Thank you.

Method & Layer Break

In general, this is good advice:

1. Update your burner's firmware (if available)
http://forum.slysoft.com/showpost.php?p=12794&postcount=10

2. Use good quality media (Memorex, Ritek, Princo, Fuji, TDK from Costco, and Maxell that are not made in Japan are not good quality media). Are you using inferior blank media? If you're not using Taiyo Yuden Premium, Verbatim, Maxell Plus, or Maxell Broadcast Quality, then chances are the answer is yes.
If you use poor quality blank media, then you should expect problems.

visit http://www.redflagdeals.com/forums/showpost.php?p=4764653&postcount=25
and
http://www.redflagdeals.com/forums/showthread.php?p=3976250

3. Try lowering your burn speed (not below 4x; if you have a 16x burner and 16x rated media try writing to it at 12x instead of 16x; an 8x burn speed on 16x rated media wouldn't be a bad idea either)

4. If you're using +R, +RW, or +R DL media, change the booktype to "dvd-rom"
http://forum.slysoft.com/showthread.php?t=476 (step 3)

5. Avoid sticker labels (they tend to cause problems)

6. Try setting a custom size of 4300 in Clonedvd (but if you're using good media, you shouldn't have to) if you're using regular single layer dvd-5 (4.7GB) discs.

7. Download Nero cd-dvd speed. It's a free program. Select the tab labeled "scandisc". Insert the problematic backup disc, select the appropriate drive letter, and click "start". If Nero cd-dvd speed reports read errors, your backup is bad (which is the most likely case), your optical drive may be slowly dying, or your optical drive simply doesn't like the disc (or your choice of blank media)--even if the disc looks fine.


Bad burn quality is notorious around the end of discs (see step 6)
and also at layer breaks when using low quality DL media (use Verbatim +R DL media made in Singapore, and change the booktype to "dvd-rom")


Also, check the preview screen in Clonedvd to ensure you're backing up the proper title.


read http://forum.slysoft.com/showthread.php?t=476 fully please
 
The answer to your question is dependent on your burner, your burner's firmware, and the blank media you're using. With double layer blank media, it tends to be best to burn slower than to burn faster. With MKM 001 (verbatim +R DL, I will usually not burn faster than 4x even though the media is rated up to 8x; depending on the firmware I'm using, I will sometimes even burn at 2.4x).

With poor quality single layer blank media, it's probably best to write at half the rated speed of the blank media. With good quality blank media (I actually write at 12x to 8x rated Taiyo Yudens), you can write a little faster. However, I rarely recommend burning at 16x to 16x rated blank media. I almost always write at 12x to good quality single layer blank media. Never write at 2x on 16x rated single layer blank media.

O.K. Thank you very much for the information.
 
Back
Top