Error message

Discussion in 'AnyDVD HD (DVD issues)' started by Bluesters, Jan 28, 2007.

  1. Bluesters

    Bluesters New Member

    I am trying to backup a movie but I am getting a message

    Failed to read Drive D
    Data Error (Cyclic Redundancy Check)

    This was the first movie I have tried to backup since installing the latest version
     
  2. DetroitBaseball

    DetroitBaseball Well-Known Member

    A cyclic redundancy check (CRC) is a type of hash function used to produce a checksum – a small, fixed number of bits – against a block of data, such as a packet of network traffic or a block of a computer file. The checksum is used to detect errors after transmission or storage. A CRC is computed and appended before transmission or storage, and verified afterwards by the recipient to confirm that no changes occurred on transit. CRCs are popular because they are simple to implement in binary hardware, are easy to analyze mathematically, and are particularly good at detecting common errors caused by noise in transmission channels.
     
  3. Bluesters

    Bluesters New Member

    Thanks

    Thanks, but how do I get rid of it?
     
  4. Zer0

    Zer0 Guest

    check if scars on the disk (disk damages) or your burner are damaged.
     
  5. Webslinger

    Webslinger Retired Moderator

    "Try cleaning the movie disc. If that does not work, if you are using an external DVD drive, please disconnect and reconnect the drive to your computer. Also try using an internal drive.

    It is possible the original movie you have has some bad sectors.

    (Cyclic Redundancy Check) or CRC Error

    This can happen on various reasons:


    1) DVD media is dirty - you can try to clean it
    2) DVD media is damaged, you have to replace it
    3) Your drive is a region locked rpc2 drive, which does not allow reading of scrambled sectors from a different region and try to read a DVD from a different region.
    You can try to find a rpc1 patched firmware at www.rpc1.com
    4) Your drive is an rpc2 drive that has not yet been assigned a region. try to assign one, or try to find a rpc1 patched firmware.

    The link is there takes you too the firmware page.

    To find the firmware you currently have use this:

    http://www.videohelp.com/tools?tool=DVDInfoPro

    If it's not scratched or dirty I suggest returning it and get another one due to the manufacturer bad press (burn). "

    taken from
    http://club.cdfreaks.com/showpost.php?p=1669766&postcount=2
     
  6. mmdavis

    mmdavis Well-Known Member

    Try it again using v6.1.1.4. There seemed to have been some problems with 6.1.1.3.
     
  7. Charlie

    Charlie Well-Known Member

    You thief! Well not totally you did give me credit. Thanks web.