Discussion in 'CD/DVD/BD Drives' started by catman112, Dec 20, 2007.

  1. catman112

    catman112 Member

    My dvd/cd drive went out and I replace it and had them install a second drive. What do I need to do to be able to read and write in one step? Which drive is D and which one is E? How do I set the source and destination up? I used Sonic yesterday to read and write an old movie and it took around 2 1/2 hours. Help please. Using anydvecopypro.
    catman112 E-mail is editedout if you would like to contact personally. Thanks

    Webslinger's edit: Be contacted over email at your own risk (that goes for both the sender and the recepient).
    Last edited by a moderator: Dec 20, 2007
  2. oldjoe

    oldjoe Well-Known Member

    Check your DMA..I would assume they are in PIO MOde.