BEE movie

Discussion in 'AnyDVD HD (DVD issues)' started by ricstone, May 25, 2008.

  1. ricstone

    ricstone New Member

    i have burnt this movie once with out any problem. tried it again with the original an my copy witch works great. but the second copy wont play all the way through, it gets about half way an starts skipping an pausing. can anyone tell me what I'm doing wrong. thanks
    ric
     
  2. Clams

    Clams Well-Known Member

    Probably poor quality disks used - in which case every copy compounds errors.

    -W
     
  3. Zeratul

    Zeratul Well-Known Member

    ^sounds right, what brand of blank dvd did you use?
     
  4. Webslinger

    Webslinger Retired Moderator

    1. Update your burner's firmware (if available)
    http://forum.slysoft.com/showpost.php?p=12794&postcount=10

    2. Use good quality media (Memorex, Ritek, Princo, Fuji, TDK from Costco, and Maxell that are not made in Japan are not good quality media). Are you using inferior blank media? If you're not using Taiyo Yuden (not Valueline), Verbatim, Maxell Plus, or Maxell Broadcast Quality, then chances are the answer is yes.
    If you use poor quality blank media, then you should expect problems.


    For +R DL blank media, use Verbatim made in Singapore or MAM-A 8x +R DL.


    3. Try lowering your burn speed a little (if you have a 16x burner and 16x rated media try writing to it at 12x or 8x instead of 16x)

    4. If you're using +R, +RW, or +R DL media, change the booktype to "dvd-rom"
    http://forum.slysoft.com/showthread.php?t=476 (step 3)

    5. Avoid sticker labels (they tend to cause problems)

    6. Try setting a custom size of 4300 in whatever burning program you're using (but if you're using good media, you shouldn't have to) if you're using regular single layer dvd-5 (4.7GB) discs.

    7. Download Nero cd-dvd speed. It's a free program. Select the tab labeled "scandisc". Insert the problematic backup disc, select the appropriate drive letter, and click "start". If Nero cd-dvd speed reports read errors, your backup is bad (which is the most likely case), your optical drive may be slowly dying, or your optical drive simply doesn't like the disc (or your choice of blank media)--even if the disc looks fine.

    Bad burn quality is notorious around the end of discs (see step 6)
    and also at layer breaks when using low quality DL media (use Verbatim +R DL media made in Singapore or MAM-A 8x +R DL, and change the booktype to "dvd-rom")