I'm getting an error too

[doh]

Trying to burn an image to hard-disk or to dvd-disk gives this error.

<Unrecoverable read error at>
<LBA 2074080>

<Burn process Failed>

Using AnyDVD 6.3.1.3.
Log File attached
Error Msg attached


Any help very much appreciated!

 

[Webslinger]

Please do not post in other people's troubleshooting threads unless you wish to assist them. click http://forum.slysoft.com/announcement.php?f=18 and read fully

1. Right click the red fox icon on your toolbar-->select "rip video-dvd to haddisk". Choose your source and destination paths. Click "Copy", and wait for Anydvd ripper to finish. Remove the original disc from your system (do not use the original disc as the source--use the rip from Anydvd ripper). You can then import that rip into Nero Recode.

2. Anydvd doesn't burn. This isn't an Anydvd issue.

3. Use Nero Recode if you must use Nero.

4. Otherwise, use Clonedvd: click http://forum.slysoft.com/showthread.php?t=476

 

[Coaster]

Summary for drive E: (AnyDVD 6.3.1.3)
HL-DT-ST DVD-ROM GDRH10N 0D04 0BDBA06/06/13
Drive (Hardware) Region: 0 (not set!)

@ doh,

Welcome to the Forum.

Your DVD device doesn’t have a Region set. For the AnyDVD software program to function correctly requires that the DVD device have the Region set.

Regards,
Coaster

 

[Webslinger]

Your DVD device doesn’t have a Region set. For the AnyDVD software program to function correctly requires that the DVD device have the Region set.

That's not going to cause that error message in Nero, but . . .

i. Right click the fox on your toolbar. Exit Anydvd
ii. Click start. Right click on "My computer"--->select "properties".
iii.Click on the 'Hardware' tab--->click the 'device manager' button.
iv. Open the dvd/cdrom branch---> right click on your optical drive
v. Click "properties".
vi. You should have a region tab. From there you can select a region.
vii. Select the region that you're in
viii. Start Anydvd