OK, So I realize this may or may not be an AnyDVD Error, but Hopeing someone can confirm or point me in the right direction.
It's been a little while since I ripped any discs, maybe a month give/take. I have now ripped several in the past few days and I'm getting the same recurring error. I have two BD drives on my PC and get the same error on one of the drives, but not the other. IE the same media works in one drive but not the other and this has happened with 3 consecutive movies.
That sounds like a good case for hardware failure, but oddly enough AnyDVD shows it is reading the media just fine. That is what has me puzzled. I can't recall, but think both AnyDVD and Handbrake have had software updates recently so potentially an issue in one of the recent updates and this type of drive? The drive model number is in the AnyDVD screenshot below.
I have attached:
Any insight is greatly appreciated.
It's been a little while since I ripped any discs, maybe a month give/take. I have now ripped several in the past few days and I'm getting the same recurring error. I have two BD drives on my PC and get the same error on one of the drives, but not the other. IE the same media works in one drive but not the other and this has happened with 3 consecutive movies.
That sounds like a good case for hardware failure, but oddly enough AnyDVD shows it is reading the media just fine. That is what has me puzzled. I can't recall, but think both AnyDVD and Handbrake have had software updates recently so potentially an issue in one of the recent updates and this type of drive? The drive model number is in the AnyDVD screenshot below.
I have attached:
- Screenshot from Handbrake showing the error "No valid source or titles found." which also suggests it could be a DRM issue.
- Screenshot from AnyDVD of the drive status, looks good
- Log file from AnyDVD for the bad drive with one of those 3 movies included.
Any insight is greatly appreciated.