WandererLA
Member
Thread Starter
- Joined
- Jun 7, 2007
- Messages
- 5
- Likes
- 0
So I have been using CloneDVD2 with AnyDVD for sometime now and typically it takes me about 40min to 1 hour backing up a DVD. I have two HP DVD burners.
Anyways, I just upgraded to 2.9.09 and since then, everything I have tried burning now takes over 3,000 minutes. I soured the forums and tried defragging and verifying that my IDE settings were set to DMA. I get the same results.
So I deinstalled/reinstalled a few times and get the same results. So last night after countless hours of working on this I installed 2.9.08 and I'm still getting the same results.
Any other suggestions before I give up and try another application?
Anyways, I just upgraded to 2.9.09 and since then, everything I have tried burning now takes over 3,000 minutes. I soured the forums and tried defragging and verifying that my IDE settings were set to DMA. I get the same results.
So I deinstalled/reinstalled a few times and get the same results. So last night after countless hours of working on this I installed 2.9.08 and I'm still getting the same results.
Any other suggestions before I give up and try another application?